New Sioux model WHC1.0 Gas

Sioux Model WHC1.0PG Horizontally Fired Water Heating System
Heat output 1,080,000 BTU/Hr
Max water flowrate 85 GPM @ 24F temperature rise
High efficiency heat exchanger: Three pass 1-1/4" schedule 40 pipe heating coil built to the ASME code section IV and registered with the National Board of boiler and pressure vessel inspectors.
90% efficient heat transfer rate
Natural Gas or LP Gas fired power burner with UL listed and ASME CSD-1
approved gas train.
Rugged water pumping system:
Single stage centrifugal pump with 3 HP (2.2 kW) NEMA premium 1.25 service factor TEFC motor
Inlet Y-strainer with vacuum gauges to assist in determining cleanout
requirements
Isolation valves for easy maintenance on heat exchanger for descaling and draining
Inlet and outlet pressure gauges
Control system:
NEMA 4 electrical enclosure with machine disconnect, local emergency stop switch, and touch screen controller
Third party approved control panel to UL508a and CSA C22.2 #286-17
Safety control devices:
Individual coil outlet temperature controls and main outlet manual reset temperature limit (prevents overheating of process fluid)
Individual coil flow switches (prevents dry firing heat exchanger) and ASME relief valve (prevents overpressure condition)
Honeywell flame safeguard with status indication, self-diagnostics, and UV flame sensor
Utility Information:
460V/3Ph/60Hz – Operating current 7 amps
2" NPT water inlet and outlet
1” NPT gas inlet
12” exhaust flue gas connection
Natural Gas consumption – 1200 cubic feet per hour
LP consumption – 13 gallons per hour